Notes: All buttons except the alternator check button are disabled in alternator check mode. This helps purge excessive gas from cells. However, it is recommended that you observe the following: To reduce the risk of injury or property damage: Follow these instructions and those published by the manufacturer of any engine you intend to use with this battery charger. Consult the dealer or an experienced radio/TV technician for help. If the vehicle accessory outlet fuse opens (blows) when plugging in this battery charger, do not use this battery charger with this vehicle accessory outlet: Do not replace the vehicle accessory outlet fuse with one of a higher amperage rating. Opening the battery charger will void the manufacturers warranty. To reduce the risk of battery explosion, follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery. This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to state or province to province. Help Call customer service hotline 1-877-571-2391 4A WATERPROOF BATTERY CHARGER/MAINTAINER SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. Check to make sure that the charger is plugged in and that the light is turned on. 51 divided by the charging rate of 1.25 amps per hour . 51 divided by the charging rate of 1.25 amps per hour indicates that 40.8 hours were needed to charge the battery fully and 32.6 hours were needed to charge it to 80% so it could be used. If you need assistance regarding accessories, please contact manufacturer at 1-877-571-2391. A: Once the current has been stable at a low level for a few hours, the battery is fully charged. WARNING: The use of any accessory not recommended for use with this home appliances could be hazardous. Therefore, if used in a garage or enclosed area, the unit MUST be placed not less than 18 inches above the floor. WARNING A spark near the battery may cause an explosion. Position AC and clamp cords to reduce risk of damage by hood, door, or moving engine part. Marine batteries must be removed and charged on shore. If you want to hang something from the ceiling, you can try using a large picture hanging hook or a wire hanger. Read and understand this instruction manual before using this unit. Do not wrap them around the unit or crimp them with a tight band. Set up the battery charger and connect to the battery following steps 1 through 2 in the Charging the Battery section. Q: How much time does EverStart Maxx BC4WE 4 Amp Battery Charger require to fully charge? Check for damaged parts. Do not operate near flammable materials, fumes or gases. Manufacturer strongly recommends that this product NOT be modified and/or used for any application other than for which it was designed. Quick start guide for EverStart Maxx. By following these simple steps, you will be able to keep your flashlight running at its best! You Can Check It Out to: Put Batteries in Headlamp, Everstart Maxx flashlight is a great product that can be used in emergencies. Check the whole length of the power cord for fraying or other damage on your laptop. (2) Return the product to the retailer where product was purchased for an exchange (provided that the store is a participating retailer). Q: What is the turnaround time for a 12-volt battery? The unit has two mounting backets at the corners of the unit. that produce arcs or sparks. This manual will explain how to use the unit safely and effectively. EverStart Maxx BC40BE. FEATURES LCD Screen Charge / Voltage Button Engine Start Button Alternator Check Button Battery Recondition Button Negative (Black) Clamp Positive (Red) Clamp 120V AC Cord Storage Tabs 120V AC Plug Keep cord from heat, oil, and sharp edges. Pull by plug rather than cord when unplugging the unit. Insert the AC plug of the battery charger into a (powered) standard North American 120 volt 60Hz outlet. Therefore, if used in a garage or enclosed area, the unit MUST be placed not less than 18 inches above the floor. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. If you need to replace the battery, visit an automotive store or online retailer to find a compatible battery. When using tools or equipment, basic safety precautions should always be followed to reduce the risk of personal injury. Review cautionary markings on these products and on engine. This unit was designed for household use only. MAKE SURE THAT THE ALTERNATOR IS RATED TO SUPPORT THE APPLICATION. Clean battery terminals, taking care to avoid getting corrosive material in eyes. Use common sense. Position the RED terminal ring on the bolt of the POSITIVE battery post connector. You can then remove the batteries, metal plate, and black wire from the light. Store the unit in a clean, dry, cool place when not in use. Be sure area around battery is well ventilated while battery is being charged. Never place charger directly above battery being charged; gases from battery will corrode and damage charger. The manufacturer warrants this product against defects in materials and workmanship for a period of TWO (2) YEARS from the date of retail purchase by the original end-user purchaser (Warranty Period). - YouTube 0:00 / 1:44 Everstart Plus Battery Charger and Maintainer. To charge it on board requires equipment specifically designed for marine use. If the plug does not fit fully into the outlet, reverse the plug. For a battery without cell caps (maintenance free), carefully follow manufacturer's charging instructions. FOR THIS REASON, IT IS OF THE UTMOST IMPORTANCE THAT EACH TIME BEFORE USING THE BATTERY CHARGER YOU READ THIS MANUAL AND FOLLOW INSTRUCTIONS EXACTLY. You can use your fingers or a coin to open the flashlight. The best way to inspect the battery is by using a voltmeter. Remove the battery completely from the boat/airplane or any confined area before charging. In this case, you will need to remove the battery and replace it with a new battery before trying to charge it again. However, there is no guarantee that interference will not occur in a particular installation. This battery charger is designed so that it can be mounted on a flat surface. The positive end of the battery should be facing up, and the negative end of the battery should be facing down. When disconnecting charger, disconnect AC cord, and then remove the Terminals Rings from the battery posts. The charger is plugged. Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at 1-877-571-2391. Follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use with this unit. Pressing the alternator check button or the battery recondition button will have no effect. Do not open the battery charger there are no user-serviceable parts inside. If the battery to be charged or maintained has fallen below 2 volts, the battery cannot be recharged with this unit. The LCD screen will display the following (the clamp icon will flash, the empty battery icon and the gauge without the pointer will light): The chargers battery clamps are color-coded. Recharging carefully is the greatest strategy to ensure that your car battery lasts a long time. Use only with 12 volt systems. Make sure the battery charger is unplugged from any power source and is not connected to a battery. Q: How can I tell when a battery on a charger is fully charged? Using the Hanging Hook Charge above freezing temperature and below 40C (104F). It is not intended to supply power to a low-voltage electrical system other than in a starter-motor application. 1 Everstart Maxx BC50BE 15 Amp Automotive Battery Charger 2 OVERVIEW 3 REVERSE POLARITY ALARM 4 BATTERY CHARGE 5 ENGINE START 6 ALTERNATOR CHECK 7 BATTERY RECONDITION 8 FAQ'S 9 VIDEO 10 Documents / Resources 11 Related Posts Everstart Maxx BC50BE 15 Amp Automotive Battery Charger Everstart Maxx BC50BE 15 Amp Automotive Battery Charger So if you need a quick battery change on a tight budget but still wants to have that peace of mind for a couple of years, this battery brand should be considered. SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. Always have protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns. Q: What does the green flickering on your portable charger mean? that produce arcs or sparks. This check may not be accurate for every make, manufacturer and model of vehicle. The LCD screen will display the following: Press the alternator check button to start the check. Recommended accessories for use with your tool may be available from the manufacturer. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove grounded terminal from battery first. Output: 12V DC, 4A, Imported by Baccus Global LLC, Insert the AC plug of the battery charger into a (powered) standard North American 120 volt 60Hz outlet. WARNING RISK OF EXPLOSIVE GASES: WORKING IN THE VICINITY OF A LEAD ACID BATTERY IS DANGEROUS. This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to state or province to province. Once you have determined how much voltage is remaining in the battery, you can decide if it is necessary to charge the battery. For positive-grounded vehicle, connect NEGATIVE (BLACK) clamp from battery charger to NEGATIVE (NEG, N, ) ungrounded post of battery. EverStart Maxx BC4WE 4A Waterproof Battery Charger Manual Questions? It also works in a variety of vehicles. Turning off the controls will not reduce this risk. An extension cord should not be used unless absolutely necessary. Your email address will not be published. Save my name, email, and website in this browser for the next time I comment. Do not operate this unit in a closed area or restrict ventilation in any way. A: Remember that if you use a slow charger, the battery charging time should be between 10 and 12 hours. Some chargers display a fault mode (constant flashing), while others are completely inactive. EverStart Plus and EverStart MAXX BC50BE 15 Amp Automotive Battery Charger are the two most often used AGM (absorbed glass mat) battery versions. Do not connect clamp to carburetor, fuel lines or sheet-metal body parts. Connect the Positive (RED) battery clamp to the Positive battery post (marked POS, P, + or red). The manufacturer warrants this product against defects in materials and workmanship for a period of TWO (2) YEARS from the date of retail purchase by the original end-user purchaser ("Warranty Period"). Check polarity of battery posts. Check battery charger and components periodically for wear and tear without opening or disassembling it. A: The charger wont recognise a functional battery hookup and wont pass current if the battery voltage is below the specific level of the charger. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to state or province to province. Have plenty of fresh water and soap nearby in case battery acid contacts skin. If the plug does not fit fully into the outlet, reverse the plug. It is hard to believe that inexpensive batteries can perform better than those that cost twice as much, but their efficiency is proved by the latest Consumer Reports tests.
Is Charlene Tilton In Yellowstone,
Bar Rescue Miles From Success Update,
Decision Rule For Rejecting The Null Hypothesis Calculator,
Capa Pittsburgh Tuition,
Articles E
